Because the water quality is relatively hard, impurities in the water will separate and become water alkali or scale when it boils. Over time, these impurities will accumulate around the faucet valve, making it difficult or even impossible to turn the faucet completely. In this situation, please ask the property personnel to clean the faucet or directly replace the faucet.
The main reason for the water heater faucet not flowing water is that the faucet is blocked. There is a filter at the outlet of the faucet, which is the simplest to block and can be unscrewed to take a look. Secondly, the cold water pipe may have been blocked by debris, the pipe diameter may have been reduced due to welding of the PPR pipe, and there may also be a water valve that has not been fully opened.
How long has the water heater been? Has the fire exhaust been rotten for a long time? The gas output is too high.
Solution:
1、 After tightening the faucet screw (at the bottom of the sink countertop).
2、 Apply some cooking oil around the rotating seam and repeat the rotation.
3、 After being flexible, wipe off the oil stains.
文章源自:開(kāi)平開(kāi)水器龍頭 http://aktinlabs.com/
12-06
Manufacturer of water heater: Maintenance methods for water heaters
Maintenance methods for water heatersA water boiler is a type of drinking water equipment that uses electricity or gas to produce boiled water. The machine is easy to operate, has a beautiful appearan
11-11
Water heater manufacturer: advantages of stepper electric water heaters
The advantages of stepper electric water heatersMany people are currently quite familiar with electric water heaters, and we can see their traces in many places such as enterprises, factories, schools
10-14
Is the "high flux" water purifier really good
Looking at the water purification market in the past two years, high-frequency words are undoubtedly "high flux". Haofan Water Purification Enterprise regards "high flux non tank pure water machine" a
02-19
What is the possibility that the faucet of the water heater cannot discharge water?
1. It may be due to poor contact of the water level wire, with the plug on the circuit board under the machine and unplugged from the beginning (the overflow water flow is large, which is the problem)